1 introduction, 1 general, 2 principle of operation – Bronkhorst CEM W-300B User Manual

Page 7: 3 cem set-up

Advertising
background image

BRONKHORST HIGH-TECH B.V.

Mix

Liquid

Gas

C

ONTROLLED

VAPORATOR

E

M

IXER

Control valve assembly

Purge connector

Liquid-gas mixing

device

Liquid

Gas

Heat exchanger

Process

1 Introduction

1.1 General

The Bronkhorst HIGH-TECH B.V. series CEM system is a unique

system to realise Mass Flow Control of vapour & mixtures,

containing up to 1200 g/h vapour. A complete system is a

combination of a mixing valve, a heating device, a liquid meter with

control function and a mass flow controller for the carrier gas. The

liquid flow through the liquid meter is controlled by the mixing valve.

A complete system also incorporates a readout/control unit,

including power supply for operation of the CEM system

devices.

1.2 Principle of operation

The abbreviation

"CEM" stands for:

"C" the control of a flow of gas mixture, gas, liquid or liquid/gas mixture

"E" the evaporation of a flow of liquid/gas mixture by means of a temperature controlled heating device

"M" the mixing of a gas and a liquid (vapour).

At room temperature the liquid, for instance water or TEOS, is drawn from a container with an inert gas

blanket, or membrane, and measured by a liquid mass flow meter type µ-FLOW* or LIQUI-FLOW

®

*. The

required flow rate is controlled to the setpoint value by a control valve that forms an integral part of the CEM

system.

A carrier gas, controlled by a MFC* is used to stimulate the evaporation process as a mixing component, and

furthermore to transport the vapour.

The process is highly repeatable and efficient.

Subsequent total evaporation of the liquid is achieved in the CEM.

* For operation of these devices consult the appropriate instruction manuals.

1.3 CEM set-up

The CEM system is built up around 3 different parts; a control

valve, a mixing device and a heat exchanger in which heat is added

to the mixture of fluids for evaporation and furthermore to prevent

condensation. The temperature of the heat exchanger is controlled

by a temperature controller which is part of the readout and control

unit.

9.17.042 page 7

Advertising
This manual is related to the following products:

CEM