11 hf q control, 12 hf frequency, boost/cut control – Cadac C-Type User Manual

Page 18

Advertising

2-4

Input channel module 7911

C-Type

Revision C2005-2

514144 +)#4#FRQWURO

The Q-control varies the bandwidth of the boost/cut at the frequency chosen (Q is
only available at the default BELL response). A low Q-value gives a wide bandwidth.
This means that a relatively large range of frequencies, either side of the centre fre-
quency, have boost/cut applied. When the Q-value is high, the bandwidth is reduced
so that a much smaller range of frequencies have boost/cut applied.

514145 #+)#)UHTXHQF\/#%RRVW2&XW#FRQWURO

Dual ganged control allow you to choose the “centre” frequency at which the boost/
cut is applied and to define the amount of boost or cut applied to the high frequency
band.

2.1.12 HF Frequency, Boost/Cut control

2.1.15 MF Frequency, Boost/Cut control

2.1.17 LF Frequency, Boost/Cut control

2.1.21 HP Filter Frequency control

2.1.23 Aux Sends 1-4 level controls

2.1.25 Stereo foldback

2.1.27 Direct Output level

2.1.11 HF Q control

2.1.13 HF EQ Bell/Shelf switch

2.1.14 MF Q control

2.1.16 LF Q control

2.1.18 LF EQ Bell/Shelf switch