Cadac CDC four - Manual (Page 11)

Revision 1 2012-13 CDC FOUR
11
Mechanical details
NOTE: when installing the CDC FOUR in a permanent or semi-permanent
situation, an additional allowance must be made at the rear of the console for
connectors and cables.
Fitting the rack mounting kit
The CDC FOUR is supplied with a pair of rack mounting brackets which permit
the mixer to be installed in a standard 19” equipment rack.
To install the brackets, remove the three upper screws (those closest to the mixer
control surface) which secure each metal end cheek to the chassis. Fit the rack
mounting brackets over the end cheeks and refit the three screws. Note that
the brackets are handed (i.e., one is designed to fit on the left hand side of the
console and the other to the right). This is indicated by an ‘L’ or ‘R’ label affixed
to the bracket.
569.6
180.8
85.5
520.0
9.2
436.0