Cadac CDC four - Manual (Page 20)

20
Revision 1 2012-13 CDC FOUR
The SEL button
Each fader (except the stereo master) has a SEL button in addition to the usual
MUTE and SOLO. The channel for which the CAM is active is selected by
pressing SEL. Only one SEL button can be selected at a time.
Thus, if the SEL button above Fader 5 is pressed, the CAM will adjust the
parameters of whatever signal is currently assigned to that fader. (Note that each
fader, and hence each SEL button, may be assigned to one of up to five possible
signals within the mixer. This concept is discussed further under “Layers”, see
page 23.)
The controls on the CAM are now discussed in more detail:
Input stage:
TRIM - input gain trim.
48v – phantom power at the mic input.
REV – phase reverse.
HPF – variable-frequency high-pass filter.
HPF – high-pass filter frequency.
Dynamics section:
GATE: THR – noise gate threshold.
GATE: IN – noise gate in/out.
COMP: THR – compressor threshold.
COMP: RAT – compressor ratio.
COMP: LVL – compressor gain make-up.
COMP: IN – compressor in/out.
COMP: AUT – sets compressor attack/release times automatically
COMP: VIN – selects “vintage” compressor algorithm.
LIM: THR – limiter threshold.
LIM: IN – limiter in/out.
BYP – dynamics section in/out.
PST – dynamics section post-EQ.
Delay section:
DLY – delay time.
DLY: IN – delay in/out.
CH 1
10
5
0
5
10
20
30
40
50
60
∞
+
0
-
ST 1
GP 1
CH 17
CH 33
SEL
SOLO
MUTE
+ -
+ -
TRIM
HPF
48V
REV
HPF
S mS
+ -
+ -
+ -
+ -
20:1 1:1
LIM
THR
DLY
COMP
GATE
LVL
RAT
THR
THR
IN
IN
AUT
VIN
IN
IN
BYP PST
S mS DLY
IN