Caple C736GSS - Manual (Page 18)

INSTALLATION IN KITCHEN CABINET WITH DOOR
The fixture has to be made according to specific requirements in order to prevent
the gas burners from going out, even when the flame is turned down to minimum,
due to pressure changes while opening or closing the cupboard doors.
It is recommended that a 30 mm clearance be left between the cooker top and the
fixture surface (fig. 21).
FASTENING THE INSTALLATION BRACKETS
< Each cooker top is provided with an installation kit including brackets and
screws for fastening the top to fixture panels from 2 to 4 thick.
< Turn the cooker top upside down and fasten the brackets “A” to the appropriate
socket holes, without tightening the screws “B” for the moment.
< Make sure that the brackets are fastened as shown in figure 22.
FASTENING THE COOKER TOP
< Spread the sealing material “C” out along the fixture hole, making sure that the
junctions overlap at the corners.
< Insert the cooker top into the hole and position it correctly.
< Adjust the position of the brackets “A” and tighten screws “B” to block the
cooker top firmly in position.
< With a sharp cutter or trimmer knife trim the excees sealing material around the
edge of the cooker top.
18
A
B
C
2
0
m
m
m
in
.
4
0
m
m
m
a
x
.
Space for
connections
D
e
p
re
s
s
io
n
s
p
a
c
e
Door
3
0
m
m
Figure 21 Figure 22