Caple C736GSS - Manual (Page 23)

IMPORTANT: Installation must be carried out according to the
manufacturer’s instructions. Incorrect installation may cause harm and
damage to people, animals or property, for which the manufacturer accepts
no responsability.
DETAILS
< Connection to the electric power supply must be carried out by a qualified
technician and following the appropriate safety regulations.
< Before carrying out the connection to the power supply, the voltage rating of
the appliance (stamped on the appliance identification plate) must be checked
for correspondence to the available mains supply voltage, and the mains
electric wiring should be capable of handling the appliance’s power rating (also
indicated on the identification plate).
< The power point must be connected to a suitable earth wiring, in conformity to
current safety regulations.
< If the hob is supplied without a power supply plug and you are not connecting
the appliance directly to the mains, a standardized plug suitable for the load
must be fitted.
< The colours of the wires in the hob power cable may not correspond with the
colours marked on the terminals of your electrical plug. The plug should always
be wired as follows:
-
connect the green/yellow wire to the terminal marked with the letter E or
PE or the earth symbol or coloured green/yellow;
-
connect the blue wire to the terminal marked with the letter N or coloured
black;
-
connect the brown wire to the terminal marked with the letter L or coloured
red.
< It is possible to connect the appliance directly to the mains supply by means of
a heavy duty switch with 3 mm minimum distance between the contacts.
< The power supply cord must not touch against any hot surfaces and must be
placed so that its temperature does not excees 75°C at any point along its
length.
< After having installed the appliance, the power switch or power plug must
always be in a accessible position.
Note: For connections to the mains power supply, never use adaptors,
reductions or multiple power points as these may overheat and catch fire.
6. ELECTRICAL PART
23