Caple C736GSS - Manual (Page 24)

In the event that installation should require modifications to the mains supply wiring
system or if the power plug is not suitable for the type of power point available, it is
recommended that a qualified technician be called to carry out substitution.
The technician will also have to verify that the cross-section of the electric cables
on the power point match the appliance’s power rating.
IMPORTANT:
< Connection to a good earth wiring system is absolutely essential.
The manufacturer accepts no responsability for any inconvenience
caused by failure to comply with this rule.
< If the power supply cable is damaged it must be substituted by a
suitable cable available in the after sales service.
< Before carrying out any work on the electrical section of the
appliance, it must be disconnected from the mains.
REPLACING THE POWER SUPPLY CABLE
Use the same type of power supply cable.
This cable must be connected to the terminal block following the diagram in figure
29.
FEEDER SPECIAL CABLE SECTION
Type “H05V2V2-F”
Resistance to temperatures of 90°C
< 3 and 4 gas cooking hobs
2 230 VAC 50 Hz 3 x 0,75 mm
< 3 gas cooking hobs + 1 electric hotplate
2 2 230 VAC 50 Hz 3 x 1 mm or 3 x 1,5 mm
Figure 29
L
1
N (L )
2
PE
230 V~
24