Caple C736GSS - Manual (Page 22)

REGULATING THE BURNER MINIMUM SETTING
On gas valves provided with adjustment screw in the centre of the shaft
(figure 27):
< Using a screwdriver with maximum diameter 3 mm, turn the screw inside
the tap until the correct setting is obtained.
On gas valves provided with adjustment screw on the valve body (figure 28):
< Turn the screw “A” to the correct setting with a screwdriver.
< In models with a gas-lighter incorporated into the knobs, turn screw “A” via
the hole in the microswith.
For G30/G31 gas, tighten the adjustable screw completely.
LUBRICATING THE GAS TAPS
If one of the gas taps becomes difficult to turn, dismantle it, thoroughly clean with
petrol and apply special high-temperature grease.
These operations must be performed by a specialised engineer.
Figure 27 Figure 28
A
22