Caple C736GSS - Manual (Page 9)

Models fitted with electric lighter incorporated into the burner knobs.
To light one of the gas burners, push in and turn the relative knob to the maximum
aperture position (large flame symbol) and hold the knob in until the flame has been
lit (figure 7).
The sparks produced by the lighter situated inside the relative burner will light the
flame.
In the even that the local gas supply conditions makes it difficult to light the burner
in maximum aperture position, try again with the knob in minimum position.
Lighting gas burners fitted with safety valve device
In order to light the burner, you must:
< Turn the knob in an anti-clockwise direction up to the maximum aperture, push
in and hold the knob. In models with the gas lighter incorporated in the knob,
this will light the gas (figure 7). If there is no mains electrical supply, bring a
lighted match close to the burner.
< For models with push-button lighting only push the gas lighter button (fig. 6).
< Wait about ten seconds after the gaslights before releasing the knob (starting
time for the valve).
< Adjust the gas valve to the desired position.
If the burner flame should go out for some reason, the safety valve will
automatically stop the gas flow.
To re-light the burner, return the knob to the closed position and repeat the
operations for lighting.
9
Figure 7