Compuprint 4247-L03 Quick Start - Manual (Page 17)

3. Use the information under “Handling the Controller Board” on page 8 as you
remove the Controller Board from its shipping box and from the protective
package.
4. Align the left and right sides of the Controller Board with the guides in the
printer and slide it into the slot.
5. Gently push the Controller Board into the printer until it is seated in the
connector inside the printer. The Controller Board is correctly seated in the
printer when the Controller Board metal plate is aligned with the back profile
of the slot.
HC0I0034
Figure 9. Removing the two screws on the metal plate.
HC0I0035
Figure 10. Sliding the board in the slot.
Setting up your printer 9