Compuprint 4247-L03 Quick Start - Manual (Page 30)

LCD Display Messages
Table 1. Display Messages
ALTERNATE This message appears to indicate that the Alternate functions of the operator
panel keys have been selected pressing the ALTERNATE key.
BUSY M1 This message appears to indicate that the printer is printing. It is busy.
COVER OPEN
CLOSE COVER
When the printer cover is not closed correctly, the buzzer sounds and the
display shows alternately these two messages. Close the printer cover.
EJECTING The printer is ejecting the paper out of the printer.
INITIALIZING LAN This message is displayed when the LAN is reset (only if the LAN interface
board is installed).
LOAD FRONT1
LOAD FRONT2
These messages are displayed, according to the installed devices, when the
corresponding paper path is out of paper.
LOCKED MENU When the access to the Printer Setups has been locked at the power on, the
printer displays this message.
MACRO CHANGING The macro has been changed and the printer is updating the settings.
MICRO FEED DOWN The paper is fed in microsteps downwards when pressing the ↓ arrow key.
MICRO FEED UP The paper is fed in microsteps forwards when pressing the ↑ arrow key.
OPER. INTERRUPTED This message is displayed if the ALTERNATE key has been pressed to
interrupt a park procedure.
PARKING The printer is parking the fanfold paper.
PATH CHANGING The path has been changed and the printer is updating the settings.
PRESS A KEY
NVM CHANGED
The NVM has been changed. Press any key to set the printer.
RELEASE KEY This message is displayed when you can release the PROGRAM key in the
Self-test selection or in the Power-on Configuration procedure.
REMOTE CONTROL This message is displayed when the printer operates from remote control
(only if the LAN interface board is installed).
RESET & BREAK The printer received a reset and break command via interface.
SELF TEST Printing the self-test page.
TEAR IF NECESS.
EJECT PAPER
These messages are displayed when the printer receives a paper parking
command and the TEAR NO item is selected for the tear-off function. Tear
off the fanfold at a perforation before it enters the tractors and press the
PARK key to eject it out the top of the printer.
TEAR IF NECESS.
PARK PAPER
These messages are displayed when the printer receives a paper parking
command. Tear off the fanfold paper if necessary and then press the PARK
key to park the paper.
TEAR OFF PAPER
EJECT PAPER
These messages are displayed when the printer receives a paper ejecting
command (TEAR NO item has been selected for the tear-off function) but
was not able to execute it, because the paper to be ejected is longer than 18
inch. Tear off the fanfold paper and then press the PARK key to eject the
paper.
TEAR OFF PAPER
PARK PAPER
These messages are displayed when the printer has received a paper
parking command but was not able to execute it, because the paper to be
parked is longer than 18 inch. Tear off the fanfold paper and then press the
PARK key to park the paper.
22 Quick Setup Guide