Compuprint 4247-L03 Quick Start - Manual (Page 19)

Step 4 – Starting the Printer
Host Computer Connection
This printer can be connected to your host computer with the interfaces available
on the Controller Board you have found in the printer box and installed on the
rear of the printer.
There are two types of Controller Boards:
1.
Controller Board with a bidirectional IEEE1284 parallel interface and Ethernet
10/100 BaseT LAN interface.
2. Controller Board with a bidirectional IEEE1284 parallel interface, Serial
RS-232/C 9-pin interface and USB 2.0 interface.
DANGER
<1-14> Switch off printer power and unplug the printer power cord
before connecting or disconnecting a communication port, a teleport, or
other attachment connector.
Insert the host computer cable(s) into the back of the printer as shown below.
Parallel
Interface
Ethernet
Interface
Hc0I0037
Parallel
Interface
Serial
Interface
USB
Interface
HC0I0038
Controller Board with parallel interface and
Ethernet 10/100 BaseT LAN interface.
Controller Board with parallel interface,
Serial interface, and USB interface.
Setting up your printer 11