Cybex 751T Treadmill - Manual (Page 31)

Cybex 751T Treadmill Owner’s Manual
31
Max Time/Time Zones (MAX TIME = MINUTES, ZONED OR OFF):
This is the maximum amount of time the treadmill can run per user workout session. You can limit the
users time or choose ‘OFF’ to disable the Max Time. Valid choices for Max Time are OFF, 20, 30, 40,
50, 60, 90 and 120 minutes or ZONED. For ZONED, you can define a user maximum session time
based on four time zones. This allows limiting use only during busy times of the day.
This is how ZONED is configured from the factory:
ZONE1 5:01A 60
ZONE2 9:01A OFF
ZONE3 4:01P 60
ZONE4 9:00P OFF
The maximum session time is limited to 60 minutes from 5AM - 9AM and from 4PM to 9PM in this
example, with all other times unlimited. The zone start/stop time and the time limit in each zone can
be modified to suit your needs.
Pause Time (PAUSE TIME):
This is how long the treadmill retains and displays your current workout data during a pause in the
workout. Choices include: Off; 1 minute; 5 minutes; and 10 minutes; default is Off.
WARNING: Serious injury or death can occur. To avoid injury or death the following
procedure must be followed. It is strongly suggested to not allow any user
on the treadmill without adequate instruction. The use of a treadmill at high
speeds can be dangerous and potentially result in injury. To avoid injury no
user should be allowed to use the treadmill at a speed that exceeds their level
of ability.
The 750T Treadmill has been programmed to have a default maximum speed of 12.4 mph from the
factory. As the owner of this treadmill you may change the default setting for maximum speed up to
15 mph. Please be aware that higher speeds have higher risk and if a user exceeds their ability, they
can potentially loose coordination that can result in injury.
The e-stop clip should be worn at all times.
Max Speed (MAX SPEED):
This is the maximum speed the treadmill will run. Choices are between .5 and 15.6 MPH (0.8 to
25.1 kph). Default MAX SPEED is set at 12.4 MPH (20.0 KPH).
Max Incline (MAX INCLINE):
This is the maximum elevation the treadmill will incline. Choices are between 0 and 15 percent grade.
Setting both the Min and Max incline to 0 percent will disable the elevation.
Min Speed (MIN SPEED):
This is the minimum speed the treadmill will run. Choices are between .5 and 1.0 MPH (0.8 to 1.6
KPH).
Min Incline (MIN INCLINE):
This is the minimum elevation the treadmill will decline. Choices are between -3 and 0 percent grade.
Setting both the Min and Max incline to 0 percent will disable the elevation.
Sound (TONE - ON/OFF):
This option will enable or disable the beeper by toggling it on/off. Default is On.