Cybex 751T Treadmill - Manual (Page 47)

Cybex 751T Treadmill Owner’s Manual Cybex 751T Treadmill Owner’s Manual
47
ERROR 98 - Display Communications lost. Without drive belt movement. The drive lost
communications with the display, where the display has not sent a valid response in 400 ms.
ERROR 99 - Display Communications lost. With drive belt movement. The drive lost
communications with the display, where the display has not sent a valid response in 400 ms.
ERROR 103 - Input Current OC trip (110 VAC only). Drive measures a high current peak on the
input line.
ERROR 105 - Thermal Integrator of Input Current (110 VAC only). Input current is out of expected
range.
ERROR 140 - Can not find home position on power-up. The display does not receive a signal from
the zero position switch during power up.
ERROR 141 - Can not find home position in normal use. The display does not receive a signal
from the zero position switch during use.
ERROR 142 - Out of incline range (over 15% or lower than -3%). The display receives a position
switch report that is outside of expected limits.
ERROR 150 - Out of Speed Range (over 150hz). The display receives a report of belt speed that is
over the expected speed.
ST6 – SERVICE
Displays the count-down to the next required service in miles or kilometers remaining. Also allows for
resetting this odometer when a service has been performed.
Displayed as “SERVICE IN XXXXX MI (or KM)” where XXXXX is the distance until the next scheduled
maintenance. The odometer is set to 15,000 miles (24,140 Km). The Odometer counts down from
15,000 (24,140 Km) miles to 0 before displaying the Service message. Press and hold the CLEAR
key for three seconds while displaying the service odometer will reset it to 15,000 miles (24,140 Km).
ST7 – PGM USAGE
Each program has an individual usage meter associated with it to allow you to track frequency of use.
Displayed as “PR Y XXXXXX” where Y is the program number and XXXXX is the number of times
this program was started (program chosen, setup completed and the treadmill enters Active Mode.)
Use the Speed Control Keys to scroll through the 9 fixed and 9 custom program slots and view the
number of starts for each.