Daktronics All Sport 2000 Series - Manual (Page 33)

Swimming Operation
Track Operation
Refer to the information in Section 3 to start up the console and use the overlay It is recommended
that Section 3 be read carefully to fully understand the following operation instructions.
Note: Not all of these keys will be used for all the codes.
Team Keys
< HOME SCORE• >
Edits the home team score
< SCORE+1 >
Increases the team score by one
< GUEST 1 SCORE• >
Edits the guest team score
< GUEST 2 SCORE (EVENT) >
Edits the score for guest 2 or the event number
< GUEST 3 SCORE (HEAT) >
Edits the score for guest 3 or the heat number
< DIM >
Dims the scoreboard for night viewing. Press this key again to return the digits to full
brightness.
Game Keys
< PLACE• >
Edits the place number
< LANE• >
Edits the lane number
< TRAINING MODE• >
Enters the training mode. In this mode, a tape switch for start and a photo cell for the
finish are brought into the external start/stop input. This allows for automatic timing of
runners. Holding the tape switch for two seconds to reset the timer and enable it. When
the tape switch is released, the timer starts. The timer is stopped when the photo cell at
the finish is activated.
< RESET• >
Resets the training mode