DFI CM100-C - Manual (Page 14)

www.dfi.com
14
Chapter 2 Hardware Installation
Chapter 2
JP5 (for USB2.0 0-3), JP6 (for USB2.0 4-5), JP7 (for USB3.0 0-1) and JP8 (for USB3.0 2-3) are
used to select the power of the USB ports. Selecting +5V_standby will allow you to use a USB
device to wake up the system.
USB Power Select
USB 3.0
0-1 (JP7)
USB 3.0
2-3 (JP8)
2-3 On:
+5V_standby
1-2 On: +5V
(default)
1
3
2
1
3
2
Important:
If you are using the Wake-On-USB Keyboard/Mouse function for 2 USB ports, the
+5V_standby power source of your power supply must support ≥1.5A. For 3 or more
USB ports, the +5V_standby power source of your power supply must support ≥2A.
PS/2 Power Select
JP10
JP10 is used to select the power of the PS/2 keyboard/mouse port. Selecting 5V_standby will
allow you to use the PS/2 keyboard or PS/2 mouse to wake up the system.
BIOS Setting
Configure the PS/2 keyboard/mouse wake up function in the Power Management Setup
submenu of the BIOS. Refer to chapter 3 for more information.
Important:
The 5VSB power source of your power supply must support ≥720mA.
USB 2.0
4-5 (JP6)
USB 2.0
0-3 (JP5)
2-3 On:
+5V_standby
1-2 On: +5V
(default)
1
3
2
1
3
2
2-3 On:
+5V_standby
1-2 On: +5V
(default)
1
3
2
1
3
2
2-3 On:
+5V_standby
1-2 On: +5V
(default)
1
3
2
1
3
2 2-3 On:
+5V_standby
1-2 On: +5V
(default)
1
3
2
1
3
2