DFI CM100-C - Manual (Page 30)

www.dfi .com
30
Chapter 3 BIOS Setup
Chapter 3
DFI Wakeup Configuration
This section configures the DFI Wakeup ACPI Power Managemnet Coniguration.
About Resume by PME
(PCI, PCIE, LAN).
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.11.1210. Copyright (C) 2011 American Megatrends, Inc.
DFI Wakeup ACPI Power Management Confi guration
Resume by PME
Resume by USB
Resume by PS2 KB (S3, S5)
Resume by PS2 MS (S3, S5)
Wake system with Fixed Time
Make up hour
Make up minute
Make up second
Wake system with Dynamic Time
Advanced
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Disabled]
0
0
0
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save Changes and
Reset
ESC: Exit
Resume by PME
Enable this field to use the PME signal to wake up the system (via PCI, PCIE and
LAN).
Resume by USB
When Enabled, this system uses the USB signal to carry out a wakeup event.
Resume by PS2 KB/MS (S3, S5)
When Enabled, this system uses the KB/MS signal to carry out a wakeup event.
Wake system with Fixed Time
Enable or disable System wake on alarm event. When enabled, System will wake on
the hr: : min: : sec specified.
Make up hour
Hour displays hours from 00 to 23. For example, enter 3 for 3 a.m and 15 for 3 p.m.
Make up minute
Minute displays minutes from 00 to 59.
Make up second
Second displays seconds from 00 to 59.
Wake system with Dynamic Time
Enable or disable System wake on alarm event. When enabled, System will wake on
the current time+Increase minute(s).