DFI CM100-C - Manual (Page 18)

www.dfi .com
18
Chapter 2 Hardware Installation
Chapter 2
HDMI
Graphics Interface
The HDMI port which carries both digital audio and video signals is used to connect a LCD
monitor or digital TV that has the HDMI port.
DVI-I 0/1
The display ports consist of the following:
• HDMI
• DVI-I port (DVI-D signal)
HDMI Port
DVI-I Port (DVI-D Signal)
The DVI-I port is used to connect an LCD monitor.
Connect the display device’s cable connector to the DVI-I port (DVI-D signal). After you plug
the cable connector into the port, gently tighten the cable screws to hold the connector in
place.
BIOS Setting
Configure the display device in the Chipset menu (“North Bridge” submenu) of the BIOS. Refer
to chapter 3 for more information.
RJ45 LAN Ports
The LAN ports allow the system board to connect to a local area network by means of a
network hub.
Driver Installation
Install the LAN drivers. Refer to chapter 4 for more information.
LAN 1
Features
• Intel ® WG82574L PCI Express Gigabit LAN controller
LAN 2