DFI CR101-D - Manual (Page 19)

www.dfi .com
19
Chapter 2 Hardware Installation
Chapter 2
HDMI
Graphics Interfaces
The HDMI port which carries both digital audio and video signals is used to connect a LCD
monitor or digital TV that has the HDMI port.
DVI-I
The display ports consist of the following:
• HDMI
• DVI-I port
HDMI Port
DVI-I Port
The DVI-I port is used to connect an LCD monitor.
Connect the display device’s cable connector to the DVI-I port. After you plug the cable con-
nector into the port, gently tighten the cable screws to hold the connector in place.
BIOS Setting
Configure the display device in the Chipset menu (“North Bridge Configuration” submenu) of
the BIOS. Refer to chapter 3 for more information.
RJ45 LAN Ports
The LAN ports allow the system board to connect to a local area network by means of a
network hub.
BIOS Setting
Configure the onboard LAN in the Chipset menu (“South Bridge Configuration” submenu) of
the BIOS. Refer to chapter 3 for more information.
Driver Installation
Install the LAN drivers. Refer to chapter 4 for more information.
LAN 1
Features
• Realtek 8111DL PCI Express Gigabit LAN controller
LAN 2
LAN 1
LAN 2