Chapter 3 – DFI CR101-D User Manual
Page 40
www.dfi .com
40
Chapter 3 BIOS Setup
Chapter 3
System Agent (SA) Configuration
Confi g Graphics Settings.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
System Agent Bridge Name
Graphics Confi guration
NB PCIe Confi guration
Memory Confi guration
IvyBridge
Chipset
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit
Primary Display
Auto
When the system boots, it will auto detects the display device.
IGFX
When the system boots, it will fi rst initialize the onboard VGA.
PEG
When the system boots, it will fi rst initialize the PCI Express x16 graphics
card.
DVMT Total Gfx Mem
This field is used to select the graphics memory size used by DVMT mode.
Graphics Configuration
Select which of IGFX/
PEG/PCI Graphics device
should be primary delay
or select SG for switch-
able Gfx.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Graphics Confi guration
IGFx VBIOS Version
IGfx Frequency
Primary Display
DVMT Total Gfx Mem
LCD Control
2132
350 MHz
[Auto]
[256M]
Chipset
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit
LCD Control
Select the Video Device
which will be activated
during POST. This has no
effect if external graphics
present.
Secondary boot display
selection will appear based
on your selection.
VGA modes will be sup-
ported only on primary
display.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
LCD Control
Primary IGFX Boot Display
LCD Panel Type
[VBIOS Default]
[Type 2-800x600]
Chipset
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit
Primary IGFX Boot Display and Secondary IGFX Boot Display
The options are VBIOS Default, CRT, HDMI, LVDS, DVI-I and DVI-D.
LCD Panel Type
This field is used to select the type of LCD panel used by the internal graph-
ics device.
Enabled PEG
To enable or disable the PEG.
NB PCIe Configuration
Confi gure PEG0
B0:D1:F0 Gen1-Gen3.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
NB PCIe Confi guration
PEG0
PEG0 – Gen X
Enable PEG
Not Present
[Auto]
[Enabled]
Chipset
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit