Chapter 3 – DFI CR101-D User Manual
Page 34
www.dfi .com
34
Chapter 3 BIOS Setup
Chapter 3
USB transfer time-out
The time-out value for Bulk and Interrupt transfers.
Device reset time-out
Selects the USB mass storage device start unit command timeout.
Device power-up delay
Maximum time the device will take before it properly reports itself to the Host Controller.
“Auto” uses default value: for a Root port it is 100 ms, for a Hub port the delay is taken from
Hub descriptor.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
ME FW Version
ME Firmware Mode
ME Firmware Type
ME Firmware SKU
Firmware Update Confi guration
Advanced
8.0.2.1410
Normal Mode
Full Sku Firmware
1.5MB
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit
PCH-FW Configuration
MEBx Type