Chapter 3 – DFI CR101-D User Manual
Page 35
www.dfi .com
35
Chapter 3 BIOS Setup
Chapter 3
F71879 Super IO Configuration
This section is used to configure the I/O functions supported by the onboard Super I/O chip.
Restore AC Power Loss
help.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
F71879 Super IO Confi guration
F71879 Super IO Chip
Restore AC Power Loss
Watchdog Timer
Super IO Watchdog Timer
Serial Port 1 Confi guration
Serial Port 2 Confi guration
Advanced
Fintek F71879
[Power Off]
[Disabled]
10
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit
Restore AC Power Loss
Off
When power returns after an AC power failure, the system’s power is off. You
must press
the Power button to power-on the system.
On
When power returns after an AC power failure, the system will automatically power-on.
Last State
When power returns after an AC power failure, the system will return to the state where
you left off before power failure occurs. If the system’s power is off when AC power
failure occurs, it will remain off when power returns. If the system’s power is on when AC
power failure occurs, the system will power-on when power returns.
Watchdog Timer
Enable or disable Super I/O watchdog timer.
Enable or Disable Serial
Port (COM)
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Serial Port 1 Confi guration
Serial Port
Device Settings
Change Settings
Advanced
[Enabled]
IO=3F8h; IRQ=4;
[Auto]
Serial Port 1 Configuration to Serial Port 2 Configuration
Select Screen
Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized
Defaults
ESC: Exit