DFI CR101-D - Manual (Page 25)

www.dfi .com
25
Chapter 2 Hardware Installation
Chapter 2
Standby Power LED
Standby Power LED
This LED will lit red when the system is in the standby mode. It indicates that there is power
on the system board. Power-off the PC and then unplug the power cord prior to installing any
devices. Failure to do so will cause severe damage to the motherboard and components.
Peripheral Power
Peripheral Power
4
1
+5V
Ground
+12V
Ground
The peripheral power connector supplies power to the SATA drive and IDE hard disk drive.
Connect one end of the provided power cable to the peripheral power connector and the other
ends to your storage devices.
Connect to the peripheral
power connector
Connect to
storage devices