DFI HD632-H81 - Manual (Page 22)

www.dfi .com
22
Chapter 2 Hardware Installation
Chapter 2
RJ45 LAN Ports
LAN 1
Features
• 2 Intel ® I210 PCI Express Gigabit Ethernet controllers
Two LAN ports allow the system board to connect to a local area network by means of a
network hub.
BIOS Setting
Configure the onboard LAN ports in the Chipset menu (“PCH-IO Configuration” submenu) of
the BIOS. Refer to the chapter 3 for more information.
Driver Installation
Install the LAN drivers. Refer to the chapter 4 for more information.
LAN 2
USB Ports
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with two onboard USB 3.0/2.0/1.1 ports (USB 0-1) and four
onboard USB 2.0/1.1 ports (USB 4-5/8-9). The 10-pin connector allows you to connect 2 ad-
ditional USB 2.0/1.1 ports (USB 2-3) and the vertical USB connector is designed to connect 1
external USB 2.0/1.1 port (USB 10). The additional USB ports may be mounted on a card-edge
bracket. Install the card-edge bracket to an available slot at the rear of the system chassis and
then insert the USB port cables to a connector.
BIOS Setting
Configure these onboard USB devices in the Advanced menu (“USB Configuration” submenu)
of the BIOS. Refer to the chapter 3 for more information.
10
VCC -Data +Data GND Ke
y
VCC
-Data +Data
GND N. C.
9 1
2
USB 2.0
USB 9
USB 8
USB 2.0
USB 2-3
USB 1
USB 0
USB 3.0
USB 5
USB 4
USB 2.0
LAN 1
LAN 2
USB 10
USB 2.0
1 4
VCC GND -Data +Data