Dove Systems IQ 512m - Manual (Page 3)

805.541.8292\\805.541.8293
DOVE LIGHTING SYSTEMS INC. \\3563 SUELDO STREET UNIT E
SAN LUIS OBISPO\\ CA 93401
OWNER’S MANUAL
805.541.8292\\805.541.8293
DOVE LIGHTING SYSTEMS INC. \\3563 SUELDO STREET UNIT E
SAN LUIS OBISPO\\ CA 93401
OWNER’S MANUAL
06\\ 05\\
:Manual Operation & Crossfades
The grandmaster and X and Y crossfaders should be all the way up
to make the channel faders live. Set the first scene with the channel
faders. To set the next scene, press the hold button. The hold
button lights and the display says:
New scene
Then:
Crossfaders down
Don't move the crossfaders yet! Adjust the channel faders to the
settings for the next scene. The lights on stage will not change.
When it is time to move to the next scene, move the X and Y
crossfaders all the way down, fading into the new scene. The X scene
is always the "old" held scene, while the Y scene is the scene you are
bringing up. With this in mind, it's possible to delay the fade out of
the old scene or to delay the fade in of the new scene (perhaps even
doing a fade to black betweenscenes) by delaying the motion of the X
or Y crossfader. Once the crossfaders have been moved to the down
position, the hold button goes out and the display returns to the
normal IQ512 display. At this point, the channel sliders are once
again "live." To set up a new scene, hit hold again, set the
new look, then move the crossfaders up.
The general sequence is:
hit hold,
set up scene,
move crossfaders down,
hit hold,
set up scene,
move crossfaders up.
Repeat as necessary.
:Start Up
Slide the left sliders (GM, X, and Y) all the way up. Slide the right
sliders (channels 1 through 12) all the way down. Connect the
supplied power supply ("wall wart") to the IQ512 and an electrical
outlet. The display on the IQ512 should say:
dovesystems.com
IQ512 VXXXXXX
(where “XXXXXX” is a 6 digit version #)
Slide each of the channel sliders up and down to verify that they
are controlling dimmers 1 through 12. Press each of the bump
buttons below the the channel sliders. The appropriate lights on the
dimmers should flash to full. If they do not, try restoring the default
patch (see below).
NOTE
If the IQ512 has not been powered up for an extended period of time,
it will forget the patch table. To restore the default patch table,
do the following:
1. Press both right and left arrow keys.
2. Press the down arrow key twice.
3. If the unit asks for a password, key in "911" using the channel
bump buttons.
4. Hit the down arrow key until the display says "Load 1:1 patch in
table 0?"Đ
5. Press the right arrow key. The display should say "1:1 patch loaded
in table 0"
6.Press the left arrow key to return to the normal display.