DR Power Walk-behind 13 - 17 HP (May 2001 - February 2003) - Manual (Page 17)

DR
®
ALL-TERRAIN
™
FIELD and BRUSH MOWER Safety & Operating Instructions
11
Belts
To Replace the Blade Belt
!
WARNING: Always disconnect the spark plug wire before servicing your machine.
1. Remove the black belt guard by unscrewing the black knob, lifting the cover, and pulling up and
back to remove it.
2. Release the belt tension lever (Figure 9).
3. Remove the belt from the pulley (Figure 10), then drop it from the engine pulley below the
machine.
To mount the belt, follow the above procedure in reverse.
To Replace the Drive Belt
Tools Needed:
· 7/16" socket
· 1/2" wrench
· 9/16" wrench
!
WARNING: Always disconnect the
spark plug wire before servicing your
machine.
1. Drain the gas and oil, or put the machine
on a bench.
2. Remove the blade belt following the
instructions above.
3. Remove the pin and collar (Figure 11),
then pull the power unit away from the
deck.
Figure 9 Figure 10
Figure 11