Cutting cords – DR Power Sprint (2000 - 2004) User Manual
Page 12
DR
®
TRIMMER/MOWER
™
Assembly & Operating Instructions
6
Cutting Cords
WARNING! Always turn the engine off when installing or changing cutting cords.
Figures 9 and 10 illustrate how the cords are installed on the line plates. It may look
complicated, but once you've done it a couple of times it's really very easy. There are two sets of
installation points on each line plate, 180 degrees apart. One set of holes is for larger cord (155
mil) and is marked with large arrows. The other set of holes accommodates smaller cord (130
mil) and is marked with small arrows. Always install two cords opposite each other for the best
performance.
Caution! Running the trimmer with only one cord installed, or cords installed at other than 180
degrees can cause excessive vibration and may damage the machine.
Figure 9
Figure 10