Cord installation – DR Power Sprint (2000 - 2004) User Manual
Page 13
![background image](/files/781812/content/doc013.png)
DR
®
TRIMMER/MOWER
™
Safety & Operating Instructions
7
Cord Installation
The standard cord installation method is shown in Figures 11-13. This is how your trimmer is
shipped from the factory.
1. Insert the ends of the cords into the
openings in the line plate, as shown in
Figures 10 and 11. There are different
sized arrows at the insertion points to
indicate what size cords fit the holes.
2. Push the cord through until it comes
out the center hole in the line plate as
shown in Figure 12. Adjust the cords
so the tips are even.
3. Pull the cords through the loop and
push the loop up into the line plate
groove above them, as shown in
Figure 13. Then pull the cords tight.
Note: Before trimming, engage the
cutting head with the engine running and
spin new cords for a few seconds so they
pull tight and set.
Figure 11
Figure 12
Figure 13