DR Power Sprint (2000 - 2004) - Manual (Page 25)

DR ® TRIMMER/MOWER ™ Safety & Operating Instructions 19
5. Loosen idler pulleys #1 and #2 (Figure
29). Remove the bracket from idler
pulley #1 in order to remove the belt.
6. Remove the belt.
7. Install the new belt. Make sure the
belt is on the INSIDE of idler pulley
#2, the OUTSIDE of idler pulley #1
and correctly fitted around the engine
pulley. Please refer to Figure 25 for
proper belt placement.
8. Replace the bracket on idler pulley #1
and tighten both pulleys (Figure 29).
9. Replace the lower bearing housing
plate and tighten the four set screws
(Figure 27). Do not over tighten the
set screws
10. Reinstall the bottom shield. See
page 17.
11. Reinstall the stone guard flap. See
page 17.
12. Reinstall the Mow-Ball ™ Support
assembly. See page 15.
Figure 29
Figure 30