Charging the battery, Disposing of the battery responsibly – DR Power RapidFire 5.5 HP Subaru (July 2013 - Present) Operating Manual User Manual

Page 20

Advertising
background image

20

DR

®

RAPIDFIRE™ LOG SPLITTER

Store an unused Battery in a dry environment with temperatures between +40°F (+5°C) and +95°F (+35°C). Make sure the
storage temperatures will never be outside of these limits. The lower the storage temperature is within the specified
temperature, the better as the battery will discharge more slowly at low temperatures.

Do not charge an already charged Battery. In theory, you cannot overcharge our Battery with a trickle charger; however, when a
Battery is fully charged and the charger is still on, it generates heat that could be harmful to the Battery. A fully charged Battery
will read 12V-13.2V with a voltmeter.

Do not continue to crank your Engine when the Battery charge is low.

Charging the Battery

Operate the Engine for at least 45 minutes to maintain proper Battery charge. If the Battery loses its charge, you will need to use a
trickle charger (like the DR Battery Charger) to recharge it. The Charger should have an output of 12 volts DC at no more than 2
amps.

At 1 amp the Battery may need to be charged for as long as 48 hours.

At 2 amps, the Battery may need to be charged for as long as 24 hours.

NOTE: Using the Recoil Starter and then running the Engine will not recharge a dead or significantly discharged Battery.

To connect a Battery Charger to your DR RAPIDFIRE LOG SPLITTER, follow the steps listed below.

1. Attach the Black (-) alligator clipped wire from the Charger Adapter to the Negative (-) terminal of the Battery, then attach the

Red (+) alligator clipped wire to the Positive (+) Battery terminal.

2. Plug the Charger into a standard wall outlet.

Typically, the Battery takes between 6 and 8 hours to fully charge. Do not leave the charger on the battery longer than
24 hours for a 2 amp charger, or 48 hours for a 1 amp charger as you could potentially damage the battery..

You can charge the Battery many times. The Battery lasts longer if you charge it before it is fully drained. Keep it fully
charged and at room temperature when not using your DR RAPIDFIRE LOG SPLITTER.

If the Battery does not hold its charge for very long under normal conditions or it simply won’t hold a charge, then
replace it. You can purchase replacement Batteries directly from us. To install your new Battery, follow the directions
on the previous page.

Disposing of the Battery Responsibly

The Battery is a sealed lead-acid Battery. Recycle or dispose of it in an environmentally sound way.

Do not dispose of a lead-acid Battery in a fire; the Battery may explode or leak.

Do not dispose of a lead-acid Battery in your regular, household trash. Law in most areas prohibits incinerating, disposing in a
landfill, or mixing a sealed lead-acid Battery with household trash.

When you are finished charging the battery, disconnect the charger from the outlet first, then disconnect the battery charger wires
from the battery. If you leave the battery charger wires connected to the battery, the battery will discharge itself back into the
charger.

Advertising