DR Power VT1 (1-ton) (Feb 2012 - Present) - Manual (Page 14)

14 DR ®
VERSA TRAILER
6. Install the Pivoting Tow Hitch (Figure 19) into the Tow Beam with the Swivel
facing upward.
7. Install two M12 x 50mm Bolts and Spacers, with the smaller diameter
Shoulder(s) down, (Figure 20) through the Tow Bar and Pivoting Tow Hitch.
Install a Flat Washer, Lock Washer, and M12 Lock Nut on each Bolt and
tighten with a 16mm Socket while holding the Nut with a 17mm Wrench.
Attaching the Adjustable Stabilizer Legs and Arms
Watch your feet when lowering the Stabilizer Legs.
1. Slide the Stabilizer Legs (Figure 21) all the way into each Adjustable
Stabilizer Arms and screw in and tighten the Locking Handles (Figure 22) to
hold the Legs in place.
2. Slide the Adjustable Stabilizer Arms all the way into the Operator Guard and
screw in two Locking Handles to hold the Arms in place (Figure 23).
3. Loosen the Locking Handles holding up the Stabilizer Legs until they drop to
the ground and retighten them. Remove the Jack Stand from under the
Trailer.
Figure 21
Stabilizer Leg
Stabilizer Arm
Figure 22
Locking Handle(s)
Figure 23
Locking Handles
Figure 19
Pivoting Tow Hitch
Swivel
Figure 20
M12 x 50mm Bolt(s)
and Spacers
Flat Washer(s)
Lock Washer(s)
M12 Lock Nut(s)