ESI Waveterminal 192M - Manual (Page 11)

ESI Waveterminal 192M
12
4. Waveterminal 192M Software Installation
After completing the installation of hardware for Waveterminal 192M, you need to
install its driver software to use it. The software installation is not too hard, even for
computer beginners. Just follow the steps below and you will complete it without any
hassel. The installation steps under Windows 98SE, Windows ME, Windows 2000 and
XP are a little bit different from each other. Below installation procedure is for the
Windows XP. However, Driver installation procedure is similar to other Windows
version.
* Caution: Depend on your operating system, you may need Windows install CD.
You need to prepare Windows installation CD before the installation procedure begins.
* Caution: Because of the driver characteristic, Waveterminal 192M installs several
drivers and continuously try to reboot the system. Unless the driver installation is
completely finished until the system cannot detect driver anymore, DO NOT reboot the
system. After all the driver is installed, restart your computer.
1 Turn your computer’s main power on. Windows will automatically detect a new
device has been installed and “Found New Hardware Wizard” will appear.
Choose Install from a list or specific location and click next.