ESI Waveterminal 192M - Manual (Page 26)

ESI Waveterminal 192M
27
Consumer (IEC 958 Type II)
: WT192M’s digital in/out format is S/PDIF.
7. MIC1 & MIC2 level faders
: You can change the input level of MIC by click and drag the fader(you can also adjust
fader using Mouse wheel) and the number at the bottom shows you relative amount of
level in dB.
Each MIC fader has independent +12V phantom power On/Off switch.
Caution: Please do not use software monitoring and hardware monitoring in
simultaneously.
You can’t get accurate monitoring and it may causes flange effect.
8. MON –VOL –Monitor Volume faders
MON –VOL (Input 1,2)
You can change the input monitoring level 1,2 by click and drag the fader and the
number at the bottom shows you relative amount of level in dB, by clicking it you can
mute the channel.
MON –VOL (Input 3,4)
You can change the input monitoring level 3,4 by click and drag the fader and the
number at the bottom shows you relative amount of level in dB, by clicking it you can
mute the channel.
9. HW VOL –Output Level meters and Adjust faders
1,2 3,4 5,6 7,8(Analog): Output goes to Analog Output port 1,2 3,4 5,6 7,8 directly as
you set on your application.
Click and drag to change Level. The numbers of bottom show the relative amount of
level in dB. If you click, it changes to ‘MUTE’.
DIG OUT 9,10: Output goes to Digital Output port(Coaxial and Optical) directly as you
set on your application.
MIX : See P. 25 ‘MIX circuit’.
10. MME SW VOL – Additional Level Adjust faders in MME SW
1,2 3,4 5,6 7,8 9,10