ESI K.ON - Manual (Page 13)

K.ON ESI
number. Now you can adjust the MIDI controller value by entering the desired controller number
via the numeric keypad or with the + / - buttons.
Assigning to Faders
Select the fader you want to assign via the SELECT button by pushing it several times and
browsing through the knobs. Press the CONFIGURE button and the system enters into edit mode
for the selected controller. The numeric display now displays the currently assigned MIDI controller
number. Now you can adjust the MIDI controller value by entering the desired controller number
via the numeric keypad or with the + / - buttons.
Assigning to Pedals
Enter into edit mode (start via CONFIGURE) first. Then stamp on (or release) the pedal to select
the pedal. The numeric display now displays the currently assigned MIDI controller number. Now
you can adjust the MIDI controller value by entering the desired controller number via the numeric
keypad or with the + / - buttons.
Assigning to Pitch & Modulation wheels
Enter into edit mode (start via CONFIGURE) first. Then turn the Pitch or Modulation wheel. The
numeric display now displays the currently assigned MIDI controller number. Now you can adjust
the MIDI controller value by entering the desired controller number via the numeric keypad or with
the + / - buttons.
Note: As Pitch is not defined to be any standard MIDI controller in the 0 ~ 127 range, K.ON
defines Pitch as 128. This means that you can always enter numbers from 0 ~ 128 for the Pitch
wheel where 128 means Pitch.
Finishing the Reassignment
When the controller reassignment is done (i.e. you have entered the number of the required MIDI
controller), press any function button to confirm the configuration and exit the edit mode.
Please note that the controller knob and the fader controller should be assigned with MIDI
controllers with successive variation while the pedals should be assigned with MIDI controllers
with on / off variation.
4.8 Save & Load Functions
K.ON can store up to 10 groups with user parameters. This allows you to make different
configurations and load depending on the situation.
Save
Press the and buttons at the same time to enter into save mode. The 10 groups of us user
parameters are saved under number 0 ~ 9. The numeric display shows “S-”, the number can be
selected by entering it via the numeric keypad. For instance, if you enter 0, the LEDs display “S0”.
The user parameters will be saved in group 0 then. If you are not entering a number within 2
seconds, the system returns to the state prior to the saving.
13