Flowserve HWX Worthington - Manual (Page 24)

HWX USER INSTRUCTIONS ENGLISH - 07/14
Page 24 of 40
M45 3375 (2489) 4875 (3596) 4950 (3651) 1425 (1051) 1800 (1328) 7050 (5200)
M48 4084 (3012) 5899 (4351) 5990 (4418) 1724 (1272) 2178 (1606) 8530 (6292)
M64 9750 (7192) 14083 (10388) 14300 (10548) 4117 (3037) 5201 (3836) 20370 (15025)
M68 11768 (8680) 16998 (12538) 17260 (12731) 4969 (3665) 6277 (4630) 24580 (18130)
M76 25230 (18610) 8270 (6100)
Above mentioned torques are for all screwed unions, which works under dynamical load. For all other
connections you can use a corresponding smaller torque.
Anchor bolts are usually made of 4.6 material. Tightening torques indicated in above table shall not be
exceeded.