Flowserve 1400 Valtek Logix - Manual

Valtek Part No. 164713 46-1
WARNING: Standard industry safety practices must
be adhered to when working on this or any other
process control product. Specifically, personal
protective and lifting devices must be used as
warranted.
Unpacking
1. While unpacking the Logix 1400 positioner, check
the packing list against the materials received. Lists
describing the system and accessories are included
in each shipping container.
2. When lifting the system from the shipping container,
position lifting straps in a way that avoids damaging
mounted accessories. Systems with valves up to
six inches may be lifted by actuator lifting ring. On
larger systems, lift unit using lifting straps or hooks
through the yoke legs and outer end of body.
WARNING: When lifting a valve/actuator assem-
bly with lifting straps, be aware the center of
gravity may be above the lifting point. Therefore,
support must be given to prevent the valve/
actuator from rotating. Failure to do so can cause
serious injury to personnel or damage to nearby
equipment.
3. In the event of shipping damage, contact the shipper
immediately.
4. Should any problem arise, contact a Flowserve
representative.
GENERAL INFORMATION
The following instructions are designed to assist in
unpacking, installing and performing maintenance as
required on Valtek
® Logix ™ 1400 digital positioners.
Series 1000 is the term used for all the positioners herein;
however, specific numbers indicate features specific to
a model (i.e. Logix 1400 digital positioner indicates that
the positioner uses F
OUNDATION ™ fieldbus protocol). Prod-
uct users and maintenance personnel should thoroughly
review this bulletin prior to installing, operating, or per-
forming any maintenance on the valve.
More detailed operation instructions are included in other
manuals in the owner’s manual binder; refer to them
when more information is needed.
Separate Flowserve Installation, Operation, Maintenance
instructions cover the valve (IOM 1 or IOM 27) and
actuator (IOM 2 or IOM 31) portions of the system and
other accessories. Refer to
Logix 1400 Digital Positioner
Installation & Reference Guide for details on fieldbus
implementation. Refer to the appropriate instructions
when this information is needed.
To avoid possible injury to personnel or damage
to valve parts, users must strictly adhere to
WARNING and CAUTION notes. Modifying this
product, substituting non-factory or inferior parts,
or using maintenance procedures other than
outlined could drastically affect performance or
be hazardous to personnel and equipment and
may void existing warranties.
Digital Positioner
Valtek Logix 1400