Dell DPND-523-EN12 - Manual (Page 49)

Set the BIOS boot sequence | 49
Setup Guide
12 Press Esc twice to return to the Configuration/Setup Utility main menu.
13 Use the arrow keys to select Save Settings and press Enter.
14 Press Enter again.
You see the Configuration/Setup Utility main menu again.
15 Use the arrow keys to select Exit Setup and press Enter.
16 Press Enter again to reboot the system, so you can go on to install the
Network Discovery software.
Dell Hardware
You must configure the BIOS of the Peregrine appliance to use the correct boot
sequence.
Note: The Dell 1750 and 1650 require some changes. The Dell 1850 and 2650
will work properly with the default settings.
For the Dell 1750
To set the BIOS boot sequence
In the setup, use the up and down keys to select the items and the right and left
keys to configure the options.
After you power the server on, wait until the display shows Press F2 for
Configuration/Setup.
1 Press F2.
You see the Main menu.
2 In the main menu, make sure the Item “OS Install Mode” is set to “Off.”
3 Use the arrow keys to select CPU Information and press Enter.
4 Press Enter again.