Fronius Selectiva Plus (three-phase) - Manual (Page 39)

9
EN
Options
WARNING! Operating the equipment incorrectly can cause serious damage.
The options described must only be put into operation by trained and quali-
fied personnel. In addition to the safety rules in the operating instructions, the
safety rules of the battery and vehicle manufacturers must also be followed.
Safety
RS 232 option Charging data, charging statistics and error statistics can be transferred via the integra-
ted RS 232 serial interface on the charger to a PC running a Microsoft Windows opera-
ting system. The recording interval is 2 minutes over a period of 12 hours.
Important! Knowledge of spreadsheet programs and data transmission programs is
required to work with transferred data.
Transfer data:
1.
Connect charger to PC using RS232 interface cable
2. Start data transmission program and make the following settings:
Bits per second:
9600
Data bits: 8
Protocol: Xon/Xoff
Parity: none
Stop bits: 1
3. Plug in charger
Important! If necessary, finishing charging
4. Access the data transmission menu
+ 5 seconds
5. Start data transmission
6. Open and analyse data using a spreadsheet program (e.g. Microsoft Excel)
Remote display
option Operation of the charger via the remote display works in exactly the same way as on
the charger multifunction panel.
Green LED
flashes when charging has terminated correctly
Yellow LED
flashes during charging
Red LED
flashes if an error occurs