Fronius Selectiva Plus (three-phase) - Manual (Page 42)

12
Relay board
option
(continued)
Connecting lines to the relay board
1.
Disconnect charger from the mains
2. Disconnect the battery
3. Remove housing cover
4. On the relay board, connect the analysis lines to connections (1) to (12)
5. On the front of the housing (mains cable side), put the analysis line through the
pre-installed bushing (PG 11)
6. Fit housing cover
6X9 6X8 6X7 6X6
Error message Battery 100%
charged
Battery 80%
charged
Charging in
progress
Fig. 9 Relay board: connecting the analysis lines
Max.: 250 V AC/DC, 2 A/cable
Relay board option on 14-pin plug prewired in factory.
Pin configuration relay board A6 SEL-REL-A / 14 pin plug connector AMP (X9)/ control
line
Connection
socket relay
board option