GAI-Tronics 234WM Wall-Mount Stanchion Assembly - Manual (Page 5)

Pub. 42004-308F
Model 234WM Wall-Mount Stanchion Assembly Page: 5 of 12
f:\standard ioms - current release\42004 instr. manuals\42004-308f.doc
05/11
Tempered Glass Installation for Model 84505-202
1. Remove the keps nuts, spacer brackets, and holding brackets. These parts will be used for holding the
glass in place.
2. Carefully unpack the glass from the box, located in the telephone mounting area of the Model
234WM Wall-Mount Stanchion.
3. Center the front glass left to right and top to bottom around the opening in the front panel assembly
and fasten in place using the spacer brackets, holding brackets, and keps nuts removed previously.
Refer to Figure 4 for assembly details.
N
OTE : Do not exceed 24 inch-pounds of torque on the keps nuts.
4. Repeat the above steps for both side glass pieces.
Figure 4. Glass Installation Instructions