GAI-Tronics 400-001 RigCom Stations - Manual (Page 5)

Pub. 42004-376C
Model 400-001 and 400-002NS RigCom Stations Page 5 of 22
e:\standard ioms - current release\42004 instr. manuals\42004-376c.doc
04/14
Hardware Configuration
External
The enclosure contains a push-to-call operator, an on-off/volume control operator and applicable approval
labeling. The enclosure itself has 12 cover mounting bolts located around the perimeter of the enclosure.
NO U SER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
OFF-ON VOLUME
PUSH TO CALL
GAI-TRONICS CORPORATION
P.O. BOX 1060 READING, PA 19607
SUITABL E FOR USE IN HAZARDOUS L OCATIONS
CLASS I, DIV. I, GROUPS C, D
WARNING: EXPLOSION H AZARD - DO NOT DISCONNECT EQUIPMENT UNL ESS
TO R EDUCE THE RISK OF IGNITION OF HAZARDOUS ATMOSPHERES, CONDUIT SEALS MUST BE INSTAL LED WITHIN 18 INCHES OF ENCL OSURE.
AMBIENT TEMPERATURE: -20°C TO 6 0°C
No. 400-001 - RIGCOM MASTER/SLAVE/COMMON
DATE CODE:
17R9
WARNING:
120VAC, 5 0/60 Hz, .40 0 AMP MAX. OR
KEEP COVER TIGHT WHILE CIRCUITS ARE ALIVE. CAUTION: POWER HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN TO BE NON-HAZARDOUS.
12VDC, 1.8 AMP MAX
CAUTION
RISK OF E LECTRIC S HOCK, DO NOT OPEN! !
SERVICE CENTERS: In USA: 1- 80 0-4 92- 12 12 Outside USA: 1 -61 0-7 77-1 374
~
Figure 3. Model 400-001 RigCom Station Outline
Internal
The enclosure contains a single PCBA where all customer connections are made. All connections are
made to the front cover by a single wiring harness with a plug.