GAI-Tronics 400-003 IEC / ATEX Zone 1 RigCom Station - Manual (Page 2)

Pub. 42004-460A
Model 400-003 IEC/ATEX Zone 1 RigCom Station Page: 2 of 16
f:\standard ioms - current release\42004 instr. manuals\42004-460a.doc
09/12
Important Safety Instructions
1. Read, follow, and retain instructions - All safety and operating instructions should be read and
followed before operating the unit. Retain instructions for future reference.
2. Comply with all warnings on the unit and in the operating instructions.
3. Attachments not recommended by the product manufacturer shall not be used as they may cause
hazards.
4. Do not attempt to service this unit yourself. Opening or removing covers may expose you to
dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
5. Electrical and mechanical installation and connection should be in compliance with all regulations.
This permanently connected apparatus must have an ALL-POLE MAINS switch with a contact
separation of at least 3 mm in each pole incorporated in the electrical installation of the building.
Installation
These enclosures must be installed by trained, qualified and competent personnel. Installation must
comply with state and national regulations, as well as safety practices for this type of equipment.
CAUTION
Do not install this equipment in hazardous areas other than those indicated
on the approval listing in the “Specifications” section of this manual. Such installation may cause a
safety hazard and consequent injury or property damage.
The mounting location must be flat and provide proper clearance, rigidity and strength to support the
enclosure and all contained devices.