GAI-Tronics 13382 WiFi and VoIP Addressable Amplified Speakers Manual - Manual (Page 18)

Pub. 42004-462A
Model 13382 WiFi and 13383 VoIP Addressable Amplified Speakers Page 16 of 24
f:\standard ioms - current release\42004 instr. manuals\42004-462a.doc
12/13
Mechanical Receipt Inspection
The Addressable Amplified Speaker is shipped in a cardboard container, protected from movement and
distress by a self-forming packaging material. Thoroughly inspect it as soon as possible after delivery.
In-transit damage should be immediately reported to the transportation company.
Cable Installation Safety Considerations
Interconnecting, communications, and Class 2 dc power cables should be separated from electrical light
or other Class 1 circuits by at least 2 inches. The exception is where Class 1 wiring or power circuits are
run in a raceway, or are metal-sheathed or metal-clad, or are permanently separated from the conductors
of the other circuitry by a continuous and firmly fixed nonconductor such as porcelain tubes or flexible
tubing in addition to the insulation on the wire. Communications cables and in-building wiring should be
listed and marked for the purpose according to NEC Article 800.
Required Tools
 #1 Phillips screwdriver
 1/16-inch flat blade screwdriver (for TB101, TB1 and TB3 connections only)
Mounting
Refer to “Opening the Addressable Amplified Speaker” section on page 10 and to Figure 2.
After opening the Addressable Amplified Speaker, untwist the nylon tie used for wire management.
Unplug the quick-connect fastons from the speaker and unplug the dual 7-point connectors (TB1), 2-point
connector (TB2), and 4-point connector (TB3) from the PCBA. The front section can now be completely
separated from the rear section. See Figure 5.
Mount the rear section to any flat surface using 1/4-inch diameter customer-provided screws in each of
the four 0.280-inch mounting holes in the corners of the rear section. Refer to Figure 5 for mounting hole
pattern dimensions. A Model 231-001 Pole Mounting Kit can also be used for pole or surface mounting.
Two customer-provided mounting screws are required to surface mount this kit. The kit includes four
mounting screws needed to secure the speaker to the kit’s bracket.