GAI-Tronics 393-800A RED ALERT Hands-free WiFi Telephones - Manual (Page 12)

P UB . 42004-471C
H ANDS - FREE W I F I V O IP T ELEPHONES P AGE 10 of 26
f:\standard ioms - current release\42004 instr. manuals\42004-471c.doc
02/15
Model 397-80 x A and 398-80 x A Telephones
The mounting and wiring instructions are as follows:
Figure 10. Model 397-800A Figure 11. Model 397-801A
Stanchion or Flush-Mount Applications
1. Use the supplied back box to mount the Model 397-800A, 397-801A, 398-801A and 398-802A WiFi
VoIP Telephones in flush-mount applications or in a GAI-Tronics Model 234 Series Stanchion.
Mount the back box to the structure using the appropriate hardware. Refer to Figure 15 for cutout
dimensions.
N
OTES :
1. When installing a RED ALERT ® Flush-mount VoIP Telephone in a GAI-Tronics 236-00x Series
or 238-001 Surface-Mount Enclosure, the front panel assembly mounts directly to the enclosure
(back box is not required.)
2. When mounting outdoors, the installation of a (customer-supplied) surge suppressor on the power
line is recommended.
2. Remove the tapered plug from the one of the rear cable entry holes in the back box, and install the
power and antenna cable and cable fitting. See the “Field Wire Installation” section on page 13.
3. Connect any desired peripheral devices. Refer to page 17 for connection information.
4. Perform the initial programming of the telephone. Refer to the “Programming” section beginning on
page 20.
5. Verify operation by calling to and from another telephone.
6. Attach the telephone’s front panel to the mounting flanges of the back box using the six supplied
#10-32 security screws and washers, 10–12 in-lbs. of torque recommended.