GAI-Tronics 12522-005 Speaker Replacement Kit for 297 / 298 Series Phones - Manual (Page 4)

Pub. 42003-228A
M ODEL 12522-005 S PEAKER A SSEMBLY R EPLACEMENT K IT FOR M ODEL 297 & 298 S ERIES Page: 4 of 6
f:\standard ioms - current release\42003 kit manuals\42003-228a.doc
1109
For Single Button Emergency Phones – Local Programming
1. Disconnect the E MERGENCY push button from J7, the “Emerg PB” socket on the phone PCBA.
2. Connect the E MERGENCY push button to J1, the “Call PB” socket on the phone PCBA.
3. Note the positions of jumpers J14 and J9. On the PCBA, enable auto-answer by placing a jumper
between pins 2 and 3 on J14 and disable password protection by removing the jumper from J9.
4. Connect a keypad to J13. (Part No. 51035-011 Keypad and 61504-048 Keypad Cable Assembly are
sold separately).
5. Press the E MERGENCY button. After you hear the dial tone, simultaneously press the 1 and # keys.
After you hear the confirmation tone, enter the command #2330; then enter the command #77017;
and then enter the command #79009. (A single beep after each command indicates success.) To
hang up the phone, press the E
MERGENCY button or wait 30 seconds for the phone to time out.
6. Press the E MERGENCY push button.
7. The dial tone you hear may be pulsing, but the phone is adjusting itself to compensate. When the dial
tone is steady (with no volume variations), the process is complete. Depending on the phone line and
the duration dial tone, it may be necessary to repeat this step one or more times.
8. Disconnect the E MERGENCY push button from J1, the “Call PB” socket on the phone PCBA.
9. Reconnect the E MERGENCY push button to J7, the “Emerg PB” socket on the phone PCBA.
10. Return the jumpers adjusted in step 3 to their original positions. Configure the phone for auto-answer
and password protection as required. Refer to the “Programming” section of the original phone
manual for additional details.
11. Disconnect the keypad from J13.
12. Install the phone in the back box or enclosure.
For Emergency Phones with a CALL Push Button and Keypad - Local Programming
1. Note the position of jumper J9. Disable password protection by removing the jumper from J9.
2. Press the C ALL button. After you hear the dial tone, simultaneously press the 1 and # keys. After
you hear the confirmation tone, enter the command #2324; then enter the command #77017; and then
enter the command #79009.
(A single beep after each command indicates success.) To hang up the
phone, press the C ALL button or wait 30 seconds for the phone to time out.
3. Press the C ALL push button. The dial tone you hear may be pulsing, but the phone is adjusting itself
to compensate. When the dial tone is steady (with no volume variations), the process is complete.
Depending on the phone line and the duration of dial tone, it may be necessary to repeat this step one
or more times.
4. Return the J9 jumper adjusted in step 1) to its original position.