GAI-Tronics 12522-005 Speaker Replacement Kit for 297 / 298 Series Phones - Manual (Page 5)

Pub. 42003-228A
M ODEL 12522-005 S PEAKER A SSEMBLY R EPLACEMENT K IT FOR M ODEL 297 & 298 S ERIES Page: 5 of 6
f:\standard ioms - current release\42003 kit manuals\42003-228a.doc
1109
5. The speaker volume may also be adjusted using R106 after installation. Please refer to the unit’s
original installation and user manual for details.
6. Secure the front panel assembly to the back box with the saved screws using the Model 233-001
Tamper-Resistant Screwdriver.
For Model xxx -001 Series Emergency Phones – Remote Programming with Password Enabled
1. For remote programming, a Touch-Tone (DTMF) telephone connected to a separate central office
(CO) or private branch exchange (PBX) line is required.
2. Enable the password protection feature—insert the J9 jumper on pins 2 and 3.
3. Enable the auto-answer feature—insert the J14 jumper on pins 2 and 3.
4. Using a Touch-Tone telephone, call the emergency telephone. The emergency telephone
automatically answers the call and generates a splash tone followed by a success tone (single beep).
5. Dial the four-digit password. If the password has not been altered, dial the password 2468 (factory
setting). Otherwise, dial the preprogrammed user password. A success tone (single beep) is
generated to indicate that the password has been accepted and that programming mode has been
accessed.
N OTES :
• The telephone automatically times out if 20 seconds elapse between digit entries, or if an invalid
password is entered.
• If DTMF digits have not been dialed within 3 seconds of the call initiation, the telephone remains
off-hook and the programming mode is terminated.
6. After you hear the success tone, enter the command #2324; then enter the command #77017; and then
enter the command #79009. (A single beep after each command indicates success.) To hang up the
phone, press the C ALL button or wait 30 seconds for the phone to time out.
7. If the phone has a C ALL button, press the C ALL push button. The dial tone you hear may be pulsing,
but the phone is adjusting itself to compensate. When the dial tone is steady (with no volume
variations), the process is complete. Depending on the phone line and the duration of dial tone, it
may be necessary to repeat this step one or more times.
8. The speaker volume may also be adjusted using R106 after installation. Please refer to the unit’s
original installation and user manual for details.
9. Secure the front panel assembly to the back box with the saved screws using the Model 233-001
Tamper-Resistant Screwdriver.