Genee World GV-9100 - Manual (Page 11)

9
Note: You can connect a laptop computer to the RGB IN port of side panel
using a RGB cable.
Step 4: Connect to the first video equipment with S-Video input.
In the step 2, the connection between the S-video and C-Video output
signals to the projector was established, where the RGB cable runs from
the visualiser and goes to the projector. Once the connections have been
made as detailed in the steps 2, 3, 4, input signals from the computerǃ
visualiser CCD, C-Video and S-Video are going to the RGB1 input on the
projector and will be displayed on the projector screen as RGB1. These
signals can be seen in turn when pressing “CCD/PC1/PC2” and
“S-VIDEO/VIDEO” on the control panel of the visualiser.
AUDIO
IN
S-VIDEO
OUT OUT
VIDEO AUDIO VIDEO
Video equipment
S-Video out
Audio out
Audio input
(or amplifier/speaker equipment)
Projector
S-Video Cable
S-VIDEO AUDIO
IN
PROJECTOR
Rear Panel
AUDIO IN OUT-12V- IN OUT -COMPUTER- IN
RS232
Cable
MIC PROJECTOR
Computer
USB RGB IN AUDIO IN RS232
Side Panel
RGB Output
To the
Monitor
USB Connector
AUDIO IN
OUT
AUDIO VIDEO
OUT
VIDEO AUDIO S-VIDEO
IN
S-VIDEO AUDIO
IN
PROJECTOR OUT -COMPUTER- IN OUT-12V- IN
Rear Panel