Genee World GV-9100 - Manual (Page 20)

18
CONTROLLING VISUALISER BY COMPUTER
You can control the visualiser from a computer connected with a RS232
connector.
A. Connect the computer and the visualiser using the RS232 cable.
B. Double click X:\ 232 Control\Control Panel (you can open this file from
the CD and double click it, or copy this file to any directory on your
computer’s hard drive and double click to launch it).
CONTROLLING PROJECTOR BY VISUALISER
The code writing software is used to inputting projector’s control code, then
can control various projector with the visualiser.
1. Connect the visualiser to the projector with the RGBǃVIDEOǃS-VIDEO
cables.
2. Connect the RS232 cable to the computer’s connector. The visualiser’s
RS232 port is located on its right side.
3. After completion of the connection, turn on the visualiserˈclick [start] ->
[All Programs] -> Visualiser ->
and the following
dialog box appears as below: