Greenheck Fabra Hood, Single Section with Filters, throat length less than or equal to 72 inches (471322) User Manual
Assembly instructions
®
Assembly Instructions
Step 1
Step 2
1
Fabra Hood • Form F
Step 1 Fabra hood Form F 471322
Open the shipping crates and separate the parts
according to the size of the unit (See figure No. 1 on
attached "PARTS LIST")
Figure 2 Fabra hood Form F 471322
Place the two BASE ENDS and the two BASE SIDES in
their approximate relationship to each other.
(See Figure 2) Fasten together using three (3)
1
⁄
4
-20
fasteners per corner for 5 inch high base and four (4)
1
⁄
4
-20 fasteners per corner for 12 inch high base.
Note:
Fasteners should be hand tightened only until step 4.
On some units where the difference between the
hood width and throat width is greater than 32 inches,
a REINFORCING PLATE is required in the corners of the
BASE (See Figure 2, DETAIL "A")
Figure 2
Document #471322
Fabra Hood • Form F
Single Section with Filters
Throat length less than or equal to 72 inches