Greenheck Weatherhood (472040) - Manual (Page 2)

2 Sidewall Propeller Fans • 45° and 90° Weatherhood Accessory
®
Figure 7:
Insert Birdscreen
Figure 6:
Assembly
45° Weatherhood Assembly
1. Refer to Figure 1 to identify parts for assembly.
2. Assemble front diagonal panel (4) to right side panel
(2) with 5/8 inch (16 mm) length sheet metal screws.
Overlap the flange on the front diagonal panel (4),
over the right side panel (2).
3. Repeat step 2 for left side panel (3).
4. As shown in Figure 6, assemble the top panel (1) to
the front diagonal panel (4) and side panels (2 & 3)
overlapping with the flanges. Use 5/8 inch (16 mm)
length supplied sheet metal screws.
5. Install the bottom panel (6) to the sides using the
5/8 inch (16 mm) length sheet metal screws. Place
the bottom panel (6) inside each flanged side.
6. Refer to Figure 7 and slide the birdscreen into the
bottom of the assembled weatherhood through the
openings on the underside. Place birdscreen in the
frame and rest on the flanges on each side. Fasten
screen to each side using the 5/8 inch
(16 mm) length sheet metal screws.
90° Weatherhood Assembly
1. Refer to Figure 2 to identify parts for assembly.
2. Using #12 x 5/8 inch (16 mm) screws, attach side
panels (2 & 3) to front panel (5). Overlap the sides
with the flange of the front panel.
3. Secure the front diagonal panel (4) using #12 x 5/8
inch (16 mm) screws to the front panel (5) and side
panels (2 & 3). Overlap the front panel (5) and side
panels (2 & 3) with flanges of the front diagonal
panel (4).
4. Attach top panel (1) to the front diagonal panel (4)
and side panels (2 & 3) using #12 x 5/8 inch (16 mm)
screws. Overlap the front diagonal (4) and side
panels (2 & 3) with the flanges of the top panel (1).
Figure 8:
Assembly
Figure 9
Figure 10
1
2
6
3
4
4
3
2
5
1
Swing birdscreen
down into position
Insert birdscreen
upward
4
2
Birdscreen